HELP! Installing from 1 : water line to toilet

At some point, you are going to have to get down to some nasty business and dump those black and grey water holding tanks. What you are about to do deals with gross grey water from your shower and sinks, and raw sewage from your RV toilet. This makes sense, right? If you take that cap off with the valves open, you are in for a surprise. Connect RV sewer hose. Most RV sewer hoses have bayonet-style fittings and generally make a tight seal. Make sure to use an elbow not yours, a fitting that fits snug and deep into the dump station opening. You may need to use a soft sewer gasket depending on the dump station and location. This is an important step.

Campground Hook-Ups – Boot It or Book It?

Video Of The Day Originally Posted by Matt is there a return line in the system. Is the drain line tied into the water lines?

To use only cold water the FreshSpa Dual Temperature bidet (FSW), only hook up the cold water side. To use only cold water with the PureSpa Dual Temperature bidet (PSW), cover the hot water connection at the back of the bidet with the Hot Water Supply Cap, supplied with the bidet.

Alternatives to Flush Toilets and Septic Systems by Larry Losoncy, PhD Information is available on the Internet for anyone researching alternatives to flush toilets, septic systems and hookup. Most of these products and technologies have been designed to address one or both of the two central problems presented by flushing away human waste. Traditional Flush Sanitation A single flush can use up to eight gallons of water, with a household of four people using more than two hundred gallons a day just to flush the toilet.

Categories of products and systems addressing this problem include advanced treatment systems, microbiotic treatment systems, portable potties, holding tanks, lagoon systems, evapotranspiration systems, chemical toilets, digestor tanks, composting toilets, incinerating toilets and evaporative toilets. With more treatment the waste is turned into a safer discharge, doing on site what waste treatment plants do for sewage. The tanks are then pumped and trucked away for disposal or drained into septic systems or sewers.

They are pumped periodically and are typically used for large public facilities such as rest stops and public parks. Solids settle to the bottom of the pond and the liquids evaporate. These are widely used by small towns, campgrounds, resort areas, recreation areas and clusters of homes. Depending on the methodology, these alternative systems either reduce or eliminate the amount of waste needing to be pumped.

Three factors figure into the evaluation process of these products and systems. They are appropriateness, cost of system and cost of operating. Is the system appropriate? Systems not allowed by the local codes also get ruled out unless a waiver is granted in many cases a waiver will be granted.

Fresh Water Connection

Our house runs on solar power for electricity so this is an important feature. Mother Nature composts naturally and this product follows along this guideline. Our society has a crazy system of dirtying clean water with our waste, shipping it to a treatment plant, adding potentially deadly chemicals to “clean it up”, and then put it back into our waterways again. This system is not an effective or efficient way to deal with our wastes.

The toilet has two safeguards, first the water enters the top tank from the the top, above the water level when the water gets any higher it starts draining to the bowl, keeping the water .

Drain the tank by pulling on the handle. Take a sponge and bucket to soak up the remainder of water left in the tank. If needed, use some paper towels to finish the job. Now that the tank is empty, it’s time to address the bowl. Since there’s still water left in the trap, take an ordinary plunger and press it once or twice as you would with a clogged toilet. This will force all the water out of the trap making the old toilet ready for removal. Step 2 unscrew supply line from stop Disconnect the Tank The first step in actually disconnecting the toilet from the bathroom is to unscrew the supply line from the stop using a crescent wrench.

Next, disconnect the tank to bowl nuts on the tank. Simply use a long screwdriver to hold them in the tank and then loosen them from the underside. Now the tank is free from the bowl and can be easily lifted. Step 3 flip up bolt covers and remove them Remove the Bowl Flip up the bolt covers and remove them if necessary. Loosen the bolts slightly, but make sure they don’t start to spin.

Permanent Toilets FAQ

How To Install The Bidet Toilet Seat Before you can install the bidet seat onto your toilet bowl you will have to remove the old toilet seat. You can do this by removing the two plastic toilet seat bolts that hold the toilet seat onto the toilet bowl. You will need a Flathead screwdriver and a pair of pliers to properly remove the two bolts.

There are many different brands of bidet toilet seats on the plumbing market today. Some of these bidet seats offer features like warm water, heated water and even air dryers.

The Clean Plumbers was founded by Phillip Maurici in After years of striving for excellence, Phillip came to realize the main concerns that people have when inviting a .

A toilet runs intermittently because the valve opens slightly for a few minutes. First, look for leaks. A leak in the tank can make a toilet run constantly or intermittently. But take a look just to be sure. If there are leaks around the fill valve, tighten the locknut see Photo 6. Leaks can come from cracks in the tank, too. In that case, the only reliable solution is a new toilet. At first glance, the array of toilet tank parts inside may look intimidating. There are really only two main toilet tank parts: When a toilet runs constantly or intermittently, one of these valves is usually at fault.

To determine which valve is causing the trouble, look at the overflow tube.

The Largest Selection of Toilet Flappers

Also are you implying this noise did not occur until after roof was replaced? I believe you are very likely experiencing expansion and contraction noises where the concealed plastic pipes are moving due to changes in temperature as they pass through or by a structural member especially with regards to the piping upstairs Peace Thanks for your response. The noise occurs constantly if only the tap is turned all the way to the right for cold water or when the toilet is flushed.

The noise lessens and eventually stops if the tap is turned either to the middle for warm water or to the left for hot water.

bgwsd: water – sewer hook‐up process overview If you are requesting a tap size larger than the standard ¾” tap size, contact our office before proceeding with the application, as additional information and fees are required.

Potty Humor Toilet a-Store About Us Plumbing for a Toilet Putting in the plumbing for a toilet is actually more work than putting in the fixture itself. There are freshwater pipes that will be under pressure to be connected. There are drainpipes that must also be vented and properly sloped. There are valves and couplings to be concerned about, as well. Most of the time, the average person replacing a toilet will not need to concern him or herself with this. But it is still handy to know about, just in case.

There should be a valve on the pipe near where it emerges; to this is attached a flexible hose which will lead to the toilet tank. There are several styles of piping available, plastic and copper are the most common. With plastic pipes glue is used to attach the valve. On copper pipes the valve is generally attached using a nut and a compression ring, but may also be soldered in place.

Older lines may be even smaller. The local hardware should have the appropriate valve. The drain will need to be fairly close to a stack.

Cube Portable toilet

I used it once in a while, but found it time consuming to fill watering cans and so it went mostly unused. Living near Seattle, I get about 37 inches of rain a year. I often see installed rain barrels and rainwater tanks around here used for gardens and flowers that are full and overflowing, not living up to their potential. I thought there must be a simpler way to use more harvested rainwater year ’round.

My solution was to relocate my rain barrel on my back porch and then hook it up to my downstairs toilet.

Spray down, clean up. At most places, there is a non-potable water hose – use that to spray down inside your sewer hose while it is still connected to the dump station. After that, remove the elbow from the dump station and spray it down, too.

In the real world, the challenge lies in clearing a way to the existing stack drain. Your approach varies depends whether you are below grade, in the basement, on the ground floor or higher. Preparation 1 Score the sides of an inch wide trench leading from the toilet drain to the main stack with a cement saw with a masonry blade, if you are hooking up a toilet drain in the basement. Remove the concrete floor between the scored lines with a maul or jackhammer, depending on how hard the concrete is.

You may skip this step if you have direct access to the work area from below, in cases of new construction or a situation involving on a ground-level bathroom with an unfinished basement ceiling directly underneath. Put on heavy rubber gloves. Cut out a section of the stack or drain with a reciprocating saw and place the section in a heavy bag, as it may have sludge on its interior. Test fit a TY-combo assembly for a basement project and “Y” assembly for an above-grade project.

RV Plumbing Tips for Newbies: Keep RV Holding Tanks Working

Its dimensions are 19,5 x 19 cm. The recirculating kit device works by hand-pump or optionally by foot-pump. Transport Dolly for standard Cube Armal transport dolly is very practical for moving any Cube standard cabin from one location to another.

This is a typical water drain and city water hook up. The drain simply comes from the sink drain and drains onto the ground. The city water hook up connects to a hose and supplies water directly to a faucet at the sink.

Urinal Urinals in Japan are very similar to the urinals in the rest of the world, and mainly used for public male toilets or male toilets with a large number of users. They often are, however, mounted lower compared to urinals in the West. This device was shaped like a cone and placed on the floor. However, those were never very popular, and only a few of them remain, including those underneath the now demolished National Olympic Stadium from the Summer Olympics in Tokyo , which was added to accommodate people from a wide range of cultures.

However, there are some Japan-specific accessories that are rarely found outside Japan. The Sound Princess[ edit ] An Otohime in a women’s room: The black square is the motion sensor for starting and stopping the sound Many Japanese women are embarrassed at the thought of being heard by others during urination [25] see paruresis. To cover the sound of bodily functions, many women used to flush public toilets continuously while using them, wasting a large amount of water in the process.

This device is now routinely placed in most new public women’s rooms, and many older public women’s rooms have been upgraded. The device is activated by pressing a button, or by the wave of a hand in front of a motion sensor.

How to Install a Toilet : How to Connect a Toilet Water Supply


Greetings! Do you need to find a sex partner? Nothing is more simple! Click here, registration is free!